New Seagate Hard Drives Limited To 1.5GBps

imageSome of the new 1TB Seagate drives come shipped with a 1.5GBps jumper enabled by default. The ST31000340AS drive has a jumper on the back that needs to be removed to enable 3.0GBps transfer. This "jumper secret" may also apply to Seagate drives so make sure to double check your existing and new Seagate drives for this limitation.

 

Directly from Seagate’s manual:

Serial ATA drives are designed for easy installation. It is usually not necessary to set any jumpers on the drive
for proper operation; however, if you connect the drive and receive a “drive not detected” error, your SATAequipped
motherboard or host adapter may use a chipset that does not support SATA speed autonegotiation. If
you have a motherboard or host adapter that does not support autonegotiation:
•Install a jumper as shown in Figure 3 below to limit the data transfer rate to 1.5 Gbits per second (and leave the drive connected to the SATA-equipped motherboard or host adapter that doesn’t support autonegotiation) or
•Install a SATA host adapter that supports autonegotiation, leave the drive jumper block set to “Normal operation” (see Figure 3 below), and connect the drive to that adapter. This option has the benefit of not limiting the drive to a 1.5 Gbits/sec transfer rate.

 

The only issue is that the jumper comes pre-installed on these drives in particular.

Good luck and happy hard disking!

Leave a Reply

Your email address will not be published / Required fields are marked *